in your expert opinion for a first resin tint what is the easiest mix of colours either the red/yellow or blue/white wanted to do it as a bottom cutlap like the red/yellow on damascus. would i setup the cutlap as normal then mix two sets of resin for example if i was using 4kg of resin setup 3kg of white and 1kg of blue catalised then pour blue into white and stir once? then pour on and squeegee as normal?? or is there a trick to it? thanks
in your expert opinion for a first resin tint what is the easiest mix of > colours either the red/yellow or blue/white wanted to do it as a bottom > cutlap like the red/yellow on damascus.>>> would i setup the cutlap as normal then mix two sets of resin for example > if i was using 4kg of resin setup 3kg of white and 1kg of blue catalised > then pour blue into white and stir once?>>> then pour on and squeegee as normal?? or is there a trick to it?>>> thanks Pauluk the red and yellow would be easier.I am not familiar with kilograms but it is basically 3 parts yellow tint in one container…1 part red in another container.When ready catylize both containers and get going.The board I did in the pics was just poured on randomly and the squeegee did the blending pour a strip of red and a strip of yellow and you will see what happens.Just go for it there is no formula that I can explain…there was a pretty good string on this in the archives…Tom Sterne gave a few good comments…have fun R.Brucker