I’m trying to come up with a definitive answer about cure time for a surfboard, what are the variables, etc. Heat being a factor, I have access to a room size oven that is accurate to a tenth of a degree and am toying with the idea of heating a couple of boards to speed up cure time and perhaps increase strength. Has any one done this successfully or is it a foolish endeavor? thanks.
put a few tanning bed lamps in it and use UV resin, five to ten ready to sand!
i know someone who has a rack on the wall of his glassing bay with roll a roll down front who uses this method work fine, but his boards do seem to delam a lot quicker. he uses it up to a temp of 80 oC paul
i know someone who has a rack on the wall of his glassing bay with roll a > roll down front who uses this method work fine, but his boards do seem to > delam a lot quicker. he uses it up to a temp of 80 oC>>> paul One variable to consider is heating up the board when rubbing out will set back the curing process. Aloha, Kokua