Is a FCS setup going to be ok with 1 lb EPS? The skin will be 2 oz - 1/8" bender ply - 4 oz. Do I need to take any special precautions? Any rproblems with exotherm in 1 lb? I’m using RR epoxy with slow hardener.
I would insert balsa, high density or PU foam in the areas where the FCS plugs are going prior to shaping. I use Elmer’s Ultimate glue to hold down the inserts. This way you can either use an epoxy or PE base method of installing the FCS plugs. I learned this from a former sailboard builder. They were building boards with EPS back in the 80’s.
D