FCS MR TX Template and glassing them on?

General Discussion
1

 Hi. Does anyone have a template for the FCS MR TX twinnie fins they would kindly share please?

Shaping my first board, a round nose fish (5'5 x 19 1/4 x 2 1/4) and would like to glass one some ply twinnies...   Any other combos you can advise or suggest on will be well received..   From what i have read. MR TX twins are a good call and plan to plug the trailer so i get to mess around with that fin some...

If you know the details on the correct fin placement and cant/toe for this model and can set me straight on what works , please do so

 

Any advice for thickness of ply to use?  I have currently hand foiled some m3's and a little gs in 3 ply which came out nice... 

Any advise on which oz of cloth to use to glass fins on? I figure 4oz pre lam for fins, rove them on, then unsure if to use a mix of 6oz & 4oz fiberglass cloth to glass em on... Can the whole job be done with 4oz without having to order 6oz cloth.

 

Many thanks

2

Just updated this post... Sorted blank and 5'5 template, would like some help on the fin telplate above if you could , fin placements and glassing them..  I am going through as much as i can in the archive and learning as i go but to have you post here with your info is fine in my book, wether you feel like you arew repeating your self or not, if its relevant to this board it should be here...  

Thanks

3

Not one soul with an incy bit of feedback on this? Wow... Someone surely has their scoop on this

 

Regards