fin plugs for eps?

 

http://www.fronttrading.com/Welkom.html

 

best keep reactions to a minimum, epoxy can get exotherm reactions quite easily if the amines get exited… :slight_smile:

 

 

Hey Fauve,

Fellow beginner here and my first post! been doing a lot of reading here.

I can’t speak for setting those plugs in eps but i can vouch for them on quality i’ve just used a set to repair my LB and convert to quad and they were great.

Actually, I set them with epoxy resin and micro bubbles in one pour, i used the guideline hardener mix that seabase sent with their resin (2:1 - resin:hardener.) Didn’t come across any problems other than a lot of overflow. heat didn’t seem to worry the board to much although this was PU?

 

Hope this helps at all, would be cool if my first post was helpful