I am about to finish up my second board, it is RR epoxy on Biofoam, and I am totally lost on what kind of fin would complement the board. I surf in the panhandle of Florida so beachbreaks it is. I’m usaully a longboarder but a Live Oak leaf caught my attention while playing with my daughter in a park, I scanned it then went to Kinkos and had them blow it up until it was a little under 23" wide and I used that printout to make the templete, thats how it became a 5’6" board, more of a art project than anything. Although now that I am almost done I am so looking foward to trying it out. I kept a little website going to keep up with the project, www.sou-psuche.com, I would love any helpfull hints or feedback on the board. Thanks for any input on fin selection… Attached are a few photos, one will have the print out of the leaf taped to it to give you an idea of where I started this at.
And thanks to everyone on the forum, I use so much info on here, thanks again.
Sean