Herb, I need some help. *PIC*

Herb I need some help recreating the board shown below. I really like the outline on it and It looks like a great board. It is 6’0" and 20 inches wide. Do you think by looking at the picture, you might be able to tell me the nose and tail measurements, thanks.

brandon, i don’t know about the nose or tail measurements, but i’m estimating the girl in the air-brush to be a 42 double-D. forgive me, i couldn’t resist…

brandon, i took your image and pasted it to MS-Paint, created a pixel/inch scale and came up with a 12.25" nose, and a 14.5" to 14.625" tail. the scale i made strictly assumes that the board is 6’ long and 20" at the WP. the scale could be skewed a little because the board appears to be laying at a slight angle against the wall. i know you asked for herb, and i’m sure he’ll come to your aid, but maybe this will help some.

Herb I need some help recreating the board shown below. I really like the > outline on it and It looks like a great board. It is 6’0" and 20 > inches wide. Do you think by looking at the picture, you might be able to > tell me the nose and tail measurements, thanks. You might want to measure the width of the board a foot back from the nose and the width of the tail a foot up from the tail if thats the measurements you’re looking for.

brandon, i took your image and pasted it to MS-Paint, created a pixel/inch > scale and came up with a 12.25" nose, and a 14.5" to > 14.625" tail. the scale i made strictly assumes that the board is 6’ > long and 20" at the WP. the scale could be skewed a little because > the board appears to be laying at a slight angle against the wall. i know > you asked for herb, and i’m sure he’ll come to your aid, but maybe this > will help some. Ramon, that was a truly awesome and creative way to come up with those measurements, thanks a lot. Could I assume that the wings on the board are placed 1 foot up?? Brandon

i’m at my work computer now but i remember that the measurement from the very end of the swallow-tail to the center of the back plug of the side fin (the decal covering it, actually) was about 12.75". the wings seem roughly 1"-1.5" inches forward of that. http://www.routerbits.com/cgi-routerbits/loadpage.cgi?986579029_5339+profile.htm