Hot Potato Fin Install

General Discussion
1

Hello all,

First time building a Hot Potato style board and was wondering about fin placement, and angle. If you have any suggestions, please throw them out there. I am planning a 5 fin set-up.

The board is shaped to the one attached here.

Thanks!

Nate

2

I previously templated a 5’4" Sweet Potato from a friend. It’s a quad set-up though so you’ll have to figure out how far forward on the center fin.

The back pair: 4-1/4" from tail & 5-1/8" from stringer (ea.side) 1/4" toe-in total.

The front pair: 10-1/8" from tail & 7-1/2" from stringer (ea.side) 1/4" toe-in total.

Hope this helps.

3

Thanks much. I appreciate it. I may just go with 4!

4

Thanks much. I appreciate it. I may just go with 4!

5

Please read this thread…so much deleted it’s sad…whatever.

http://www.swaylocks.com/forums/wanna-bee-big-wave-gun-guy-1