OK, Even I understand that you’d only brush lengthwise
but how would get the colours so thin?
I was thinking about this recently, maybe use a sryinge for the really thin lines. I’ve seen a cup with a pin hole(s) in the bottom used before.
Maybe cleanlines will chime in here.
swirl colors mixed in very small batched, no stir, lots of clear resin. clear with red & green, clear with blue & green, etc. Pour very fine line, fast, thin like 1/2 in, tip to tail, pour, saturate,and pull at the same time, come back, laminate and pull off…once. Only work once or it will muddy. Try not to overlap pours.
What do the rails look like?
I’m not sure 'cos I nicked the picture from a local (Newquay UK) shapers
myspace page ( www.myspace.com/corduroysurf )
This is what became of the much lamented ‘Revolver’ surf shop
More board porn:
Howzit meerkat, That actually looks more like it was done on the foam instead of in the laminaton. I have done quite a few of them on the foam and like the results better, plus it seal the foam. Aloha,Kokua