Here is a rocker profile. Not quite as flat as I pictured in my head, but also remember this is the Zach Reinhardt model, which is more “shortboardy” than some of the others. I talked to a friend who is shaping himself something based on the 5’0" Ben Wei model, and it sounds like that one is much flatter to me.
I measured the nose and tail rockers on mine, but it was a little difficult because the MVG’s were bottoming out on the floor, lifting the tail and lowering the nose. I therefore balanced the board on a magazine (Surfermag big photo issue) that was approx 1/2" thick, measured the distance to the floor, and subtracted 1/2" to approximate the rocker measurements. Hopefully those are close enough.
4 & 1/8" nose rocker
1 & 5/8" tail rocker
IMPORTANT EDIT: I originally reported the width measurement as 21". It is actually 20" wide. Sorry for the goof.
I like the shape and I would say the rocker is ok for a multi fin. It could stand a bit less rocker for single I think. Also…you make try a softer rail on the tail if you want it to hold better on head high and up. Nice shape.