Hi all i am new to the forum
looking for info or tips on best and most efficient way to get this done.So i have a 9'6'' surf board i picked up used and it has alot of random dings and old not so perfect repairs. any way a fin box came out so i am refinishing the board and adding some cabon kevlar to the rear over the base of all the fin boxes. Im repairing all the old repairs, dings, etc. Then i was going to vacuum bag the entire board. were i am running into an issue is that when i wrap the board i wont be able to keep the fabric from falling on the under side. can i use green masking tape to hold the fabric to the board ? Then i was going to put one bag over and wrap the rockers of the board. i only have green peel ply at the time so refininshing the bottom may be time consuming. Here are a couple phone pics not the best quality. the green tape would be were the vacuum bag would end. also what should i use for clear coat when i am done for UV. protection? I have west sys. 207 206 205 and i am using some adhesive filler 404 i think for the holes and fine box. If anyone has any idea help would be appreciated. This is the bottom. 
