i'v shaped and glassed a 5'10" x 22" x 2.1/2" mini mal rounded nose and inverted, half moon tail. tail is about 10" wide. andyone know a good layout for a quad set up using fcs plugs. i'm thinking of lining them up 3" outside of the nose the 2 front outside fins about 4degrees of square and the back inside fins about 1degree of square. possible 1.1/2" in from rail. 4" from tail for inside fins and 8.1/2" for outside fins.
any better suggestions?
cheers
Hi, I got measurements for something like that but I do all my fins in cm so probably no use to you:)
I suggest checking out the Mckee Website, just google Mckee and surfboards, has a great table to give you all fin placements for quads in a variety of board lengths.
Are you sure your tail is 10" wide that sounds really narrow for a 22" wide board? Normally I think the tail is measured at 12" from back of board or end of tail, that may be the point you measured?