Quick Glassing Help ??

General Discussion
1

Hey guys.

Recently hoat coated the top and bottom of that fish i was making for my mate.

I kinda buggered to bottom though. I stupidly didnt mix enough resin and ended up having a couple of dry patches.

Same stupid thing happened with my first fish and it ended up having visible joins in the two sets of resin used on the hot coat (it didnt have a glosss coat though)

So question is… Should i just mix a little bit of resin and fill the dry patches. Then sand and gloss coat and there will be no lines OR

is there some other method i should use ?

P.s. sanding the hot coat after putting in those patches for the dry bits is amazingly crappy.

Cheers in advance

2

Let the hot coat totally cure, and then go slow and sand it all off back to the lam layer… then hotcoat again, and make sure you have excess…

Or if you dont have time, coat the dry patches… sand it all level… if there is lines, paint over it and spray 2pac or clear acryllic over it.

Ant