The same problem has happened twice to me now. i sandwhich my graphic in between my two 4ounce deck layers near the nose. I lay down a bit of lam resin under first for a good seal to the board, then laminate normally, and while it is going off, there is no problem. After it hardens however, the rice paper bubbles up off the board a bit. I have made a small slice and injected resin back under, but it dosent seem to look right. any suggestions? Thanks for the help JT
I use to have the same problem. Know I oversaturate that area and don’t squeegee it out until dead last. I was never able to fix it after the damage was done.