Ive just finished glassing two boards and I am ready to put the plugs in the board. the only thing is that i have the plugs, sticky foam for overflow, and the hardner but not tool to set the plug like in the installation video. I also do not have the placement jig made yet, i have a few ideas in my mind as of what to do. Would like the knowledge of this forum to get me on the right path. thanks trev
The best tool to use in my opinion is a hole saw. you can pick one up at most hardware stores or Electrical supply houses.When you get your hole saw, with the 1/4 inch pilot bit drill a peice of 1"x4"x6" long board for your jig. Then take out the pilot bit (this will help you not drill a hole thru your board) then measure the depth of your plug and mark your hole saw with a black marker.Be sure to compesate for the jig thickness then place the hole saw in the jig and drill.
Howzit Trevor, you don’t say which fin system you want to install.Aloha, Kokua