8' egg ready to glass.

General Discussion
1

Well this bad boy’s ready to glass now, fixed up those colors right this time, just waiting for some artwork and epoxy to arrive, and it’ll be a surfboard …

specs 8’ long, N 17", T 14.5", wide point 22" about 6" or so forward of center. Rockers abt. 4" N and 3" T.

Rails 50/50 egg on nose, tucked under edge fades in about 3 feet from the nose, and gradually drops to full down near the front of the rail fins locations.

Bottom flat to vee, going with 2+1 for fins.

Open as always to thoughts/comments/suggestions/roasts …

2

Looks sweet… try it as a single fin first, then after a few sessions, pop in the side fins and see the difference.

3

Hey EW

I have a 7’10" Quad Egg that was just finished that he is tripping over.

I wanted to do one for myself with the single fin box added but it did not look right.

So if I do I might go with 4 channels (cant really do 6 with Lokbox sides).

I’ll post pics later.

Cheers

-B~

4

In the same vain of what you are doing.

Cheers

-B~

Some vee panels in there