a million bubbles/can it be saved?

Archive 1999-2004
1

I think I must have used a bucket that was in the sanding room and now when I did my hotcoat I have about a million little bubbles. Can it be saved? Should I sand it down and gloss coat it? Will this do the trick or any other suggestions. Crap!!!

2

I would go ahead and sand the board. If after sanding I could see small holes or pitts, then I would rehotcoat and resand. If the board was to be glossed, I may just gloss it after the first sanding if the flaws were small. But that’s just what I’d do. Good luck! (Most of my glass jobs involve a certain amount of ding repair as I go along!)

3

Thanks Tuna. I sanded it and it didn’t look too bad. I need to see it by daylight. I might just gloss it anyway to be safe. Thanks again