Just bought and used this stuff to seal a board. Similar to the Behr Low Lustre. Was using the cheap Futures floor finish but that was junk. The moment I’d use the red 3m pad it would come off even lightly scuffing it. This Seal-Krete doesn’t do that. Put 3 coats on and ding ding ding winner. Probably only needed 1 or 2 but hey 3rd times a charm. Haven’t used the Behr stuff, was going to buy it but then saw the Seal-Krete. It says its good on pool decks, which the Behr was not. Seeing how pool decks are always wet, figured this might be better to get.
Zep highgloss/high traffic…then slow polish w/ lemon pledge.
Herb, wiped on? Sprayed? Brushed?
Thx
just wiped on with a fine sponge…maybe three layers…but two good coats is fine.
make sure you let them dry well between coats…also ,scrunge pad between coats to remove any zits.
the final coat can be just polished.
polish in low rpms using lemon pledge.
herb
I use whatever the acrylic sealer fiberglass Hawaii has on the rack.
My last board I tried epifanes high gloss spar varnish over epoxy. It cam out real nice and has held up so far. I had to thin it 50% with their thinner and also added cobalt drier.
