I thought some stated not to use add f over an airbrushed (acrylic) board. Couldn’t find it again in the archives. Can anyone confirm?
Quote:
I thought some stated not to use add f over an airbrushed (acrylic) board. Couldn’t find it again in the archives. Can anyone confirm?
I’m assuming you’re mixing it in some epoxy??? It’ll work just fine if used at recommended percentages. If the color is bleeding it may not be due to the xylene, it could be reacting with the epoxy. Never been an issue for me using acrylic paints. However, I have had inkjet printed lams bleed with straight epoxy during laminations in the past.