Advice on a minimal please.

General Discussion
1

Basically I’m building my next board (#2) which I’ll be starting this weekend. I’m going to be doing a 7’8 minimal but I can’t decide on how to do nose section.

I did the template on my 1st board, with an 8’ x 3" thin bendy length of stainless steel and marked out the centre width, nose and tail etc as I think most do (I may be wrong, but that’s how I learnt through researching) anyway, when it comes to the nose on a minimal is there a way of marking out the nose to get the right rounded shape? Also any other advice would be great.

Thanks in advance,
Steve.

2

Get a bigmal trace around the outside then cut a piece out of the center , minimal.

3

Hi Steve. Sent you a PM, have a couple of spin templates & rocker templates for that size! Will post them down if you send me your address. Not down your way again until May. Slanj

Smile @ strangers & use the force…

4

Thanks Rikki. Sent you a reply :slight_smile:

5

You can download from blendigcurves or make both your rocker and template in boardcad