Aku shaper copy from ghost image board

Hi guys. I am trying to copy an old rail I used on an existing board and integrate it into this new board I have been working on. I have tried using Ghost image and copying from that but its just so damn hard. Possibly if I could remove points may make it easier but I cannot see where.

Any help much appreciated :slight_smile:

open your file in shape3d and its very simmple you can copy and paste outline rockers and slices with two clicks from anouther file or just upload a image to copy from. 

is this in the full versiomn or the lite version, i didnt think you could do that in the lite  shape 3d.

Print out the old rail at full size. Blow up screen rail to same size and overlay the print on the designed one. I sometimes cut the rail out. Even with existing points you will be able to reshape the rail to match. Just takes a bit of dicking around.

Then you get to correct the flow between slices to get rid of wobbles. I use wire frame view to adjust points, but Iā€™m not sure your version of Aku can do this.