Just laminated the bottom of my first board and just wanted to clear up the whole basteing thing. On the deck I want to create a “ramp” of laminating resin between the cutlap and the foam? Im guessing this is filling in any voids before glassing the deck? I have 7.5 volan on bottom and was planning on 2x 7.5 volan on top.
You could do that. Or sand, file, or grind the edge. Or press it down into the foam with a roller. Or do an infill panel of deck glass, then wrap the next layer of glass around the rails.
Kind of wanted to triple wrap the rails so after a better look ill take them down or fill them in. Thanks
If you’re doing color work don’t baste.
So a surform and sandpaper it is!
I use a surform on foam, never on fiberglass. Sandpaper. yes, and be careful just to sand the edge, not the adjacent foam. But I work with epoxy resin.