What do you guys do, is there a consensus or standard, when doing a PU bottom hocoat on a shortboard with fin boxes; where to level your glassing racks? So that the board is most level at the -
Fin boxes
Middle
???
I like level just in front of the fins, a little down-hill at the tail so the resin pools into the masking tape dam at the tail, without overflowing.
Most guys I know jack up the tail to do their post-glass box or FCS install, then hotcoat with board shifted a little noseside to get the bead in tail correct. Kinda depends on how far up you want the built-up edge to run.