I tried doing 3 layers of 4oz fibeglass for the first time. I got a bunch of bubbles underneath the glass. I tried to sqeegee them out but no go. Is there a way to prevent this from happening or should I just do 2 layers first and then put the 3rd one on later? Will the bubbles make the board delam or crack easier?
I tried doing 3 layers of 4oz fibeglass for the first time. I got a bunch > of bubbles underneath the glass. I tried to sqeegee them out but no go. Is > there a way to prevent this from happening or should I just do 2 layers > first and then put the 3rd one on later? Will the bubbles make the board > delam or crack easier? …for you ya,do 1 then 2 layers,or just use more resin,and set it off alittle faster.The air is from the resin going off to slow(most likely).Herb
…for you ya,do 1 then 2 layers,or just use more resin,and set it off > alittle faster.The air is from the resin going off to slow(most > likely).Herb Actually, the resin went off faster than usual because I put more MEKP than usual (1/4 oz. catalyst to 24 oz of resin). It took about 10 min.or less. So if I put one layer first, I can just put the other two on top with no prob or doing anything special like sanding right? Thanks.
Actually, the resin went off faster than usual because I put more MEKP > than usual (1/4 oz. catalyst to 24 oz of resin). It took about 10 min.or > less. So if I put one layer first, I can just put the other two on top > with no prob or doing anything special like sanding right? Thanks. …If it’s clean enough you should have to do much.Just take off the pointys,and drips.When glassing,the cleeanner the steps inbetween,the easier,and cleaner the end product will be.Herb
…If it’s clean enough you should have to do much.Just take off the > pointys,and drips.When glassing,the cleeanner the steps inbetween,the > easier,and cleaner the end product will be.Herb Thank you Herb.