I’m asking this because I’d like to add a few panels to the Pig I’m building. I’ll likely experiment on my own unless someone has some experience to share.
All the best, Greg
Totally possible (been done before)
Because it takes so long to cure wrapping the rails can sometimes sag the color.
Stick to the flats and you shouldn’t have any issues.
Pull tape when its dry but you can still press and leave a finger print. Crispy lines.
That’s probably some of the best epoxy tape pulling advice I’ve seen. I was about to comment that resin panels are totally possible but it’s the tape lines that always mess me up. I’ve tried mostly wet, totally dry, and anywhere in between and I always end up sanding the tape lines. I would like to add, if it’s not totally obvious, you should probably use fast hardener.