Hey sways,
I’m about to embark on my first board foam board
built, needless to say excited, nervous, all around stoked! So far with
the help of grant at FAOM E-Z I narrowed down the style of board I
wanted and chose to make a nose rider as I surf SanO’ quite regularly.
I used adobe illustrator to input all my mapping points, nose,tail,wide
point etc. and went from there. Next was an early morning drive to
kinkos to have them print out a full length template. I selected the
9’8" y from US blanks again at FOAM E-Z put down my outline and made my
first cuts! Totally nerve wracking experience for sure, so afraid ill
screw up but i know I will and am looking forward to learning from that
future mistake! So for the moment ill leave you guys with those first
cut pics and hope you check back in to see the progress!
Thanks for taking the time to check it out!
9’6" Nose rider Model name to be decided (four doors special???)
18 1/2" nose
23" wide point 5" back from center
15" rounded diamond tail
Thickness undecided…
