Gas bubbling up in qcel and lifting up the glass

General Discussion
1

I put a nickel size hole 3/8" deep in the rail of my eps/epoxy longboard. When I filled the hole with qcell, it bubbled like one of those mud pots at Yellowstone. When dry, there was a pin hole the made the glass lift up into a blister. Can someone tell me how to deal with the gas? Thanks, Lon

2

Lon,

The board was blowing air which happens as the board heats up. Sand the repair and this time let the board get warm. After you finish making the repair move the board to a cooler location while the repair sets up. The air in the board will then be contracting and you shouldn’t have any problems. You do need to make sure the dinged area is dry before making the repair.

Dave_D

3

Good answer…ya what he said…later,ET