Gloss coat?

General Discussion
1

Hi Folks,

I’m shaping my first EPS shortboard, a 6’5" with thruster fins and just finished the bottom hot coat. I’m a bit short of epoxy resin and hardener. What do you suggest, just sand the hot coat and the board is ready, or after sanding get some more resin and apply a gloss coat as well. What else shall i do after sanding the hot coat on both sides? Any experience?

Thanks for help!

 

 

960×1280 260 KB

2

Go over and post on “General Discussion”.   You’ll get what you need there.

3

If you have a little resin I would sand and apply a thin finishing coat.