Today, my buddy ran over my board with his fin. I could go to Roper’s and get it professionally fixed, and I may do that if I find fixing it myself too difficult. But I wanted to post here first and ask if you guys can recommend some resources, some websites where I can learn how to do it myself. I know there’s more to it than just solar rez, so what sort of resin do I need to buy, fiberglass cloth, etc? What else do I need to consider? Do I need to fill the hole with more foam?
There are plenty of clips on YouTube that will help you.
I reckon there are a number of ways to repair it. A bit hard without a photo of the damage.
The easy way is just to use some solarres that has some chopped glass in it and fill it up. Won’t look pretty but will make it water tight.
The ‘proper’ way is to clean out the gash
Sand down a area surrounding the gash, making sure you dont sand down too much, cut a wedge of foam to fit the gash ( if it is really wide) or use some q cell mixed with resin to fill the gash.
Lay down some 4oz cloth covering the gash and the sanded down area
Mitches in La Jolla should have everything you need for the repair. After watching the Videos You just might want to take it to Joe Roper or some of the Other Ding Pros in San Diego.
Thanks guys. since it was a friend’s board, I took it to Roper’s to make sure it was done right. If I every have this happen to one of mine, I’ll attempt to fix it myself and this advice will help. thanks!