First time cutting out a center fin box and the router kicked hard on the stringer and cut outside the template line. Will the cloth and resin fill in ok or do I need to do something else to fix it? Thanks for any help!
the first pic look bad!
but with the box in the hole you will be fine, you could also use a straight edge and clean up the edges and square the hole by the stringer
the resin and cloth will hold you could also put a patch over the box.
paul
as paul said
and use white in the resin
you could try and reroute it a little longer to clean it up
or do it up as is and move on
Pinstripes and a fade flame job always draw attention away from a problem area.