Rookie mistake 101:) So i layed down a baste for grinding my deck lap and im assuming i mixed a bit too much wax and not enough hardner into the mix!! I thought id ease up on the mekp to avoid discolouration but because it was colder than usual i think it has failed to go off completely and theres a layer of gel on top of the area which im assuming is the wax/styrene rising to the surface not set. Whats the best way to clean this or remedy, so i can sand it. Have it sitting next to a heater to see if i can get it to harden more presently… Cheers
Eh,
Maybe it will harden up.
UV? no sweat!
I know crap…
But I never baste w/ SA
on nasty job I go with 40
Gums up however…
Recoat with a good one mix. More sanding…