Hey, i want to glue two three inch eps foam blocks together, but im not sure how. Do i epoxy them togther, and if so what kind of epoxy would be best? Also, i know that i could use wood glue, but i want it to look good and i have had bad experiances with it and it not turning out quite right. So i am just wondering what is best.
K thanks a lot guys, spackle is a genius idea and ill be sure to feather it a bit.
Thanks
Roo Glue or Gorilla Glue White). Use a plastic squeege or a throw away roller. If you want it to be clean use one of those little red handle rollers and a plastic tray like they sell at Home Depot. Just the right amount of glue. Don't be so sloppy. Water and a wet rag or sponge will clean it up before it sets.
Sounds good, got any tips for making it so that there isnt a visible crack down the middle where i glued them together
White Gorilla glue and spackle… 
Feather your joint on an angle and use as little glue as possible. A vertical joint always jumps out.
Spackle was going to be my next suggestion. You'll have to cover it up(spackle) and maybe even paint it white to make it disappear completly.