Im trying to get my girlfriend into surfing, so i took my board and hers out to some whitwater along a beach. i thought the beach was all sand so wasnt to worried, anyway i found some rocks in that sand. So i was being an idiot and scraped up the bottom of my board. nothing went into foam, but i scraped the hot coat of a couple little spots, exposing a slight view of the glass. two of these areas have a couple little impact spider cracks. the main area, the biggest rock, put in a noticible pressure spot into the foam and glass, about 4 inches long bout a 1/5in deep, no glass is punched through, just impact cracks. i also just have one little pressure spot, just like one would be on the deck from feet. my main concern is just keeping the board sound and keeping the ride good on it, but i do take pride in keeping it clean looking. i do all my own dings and like to get perfection, but it isnt a huge concern. what can i do for these spots? should i just fill them with sanding resin and sand it down? any info would be great, thanks
if it’s just spider cracks / scratches, i’d go with some clear acryllic spray (seals it up nicely without all the effort). if anything gouged down to the weave, slap a little sanding resin in there.