sanded hotcoat results

Hey, I sanded the hell out of my board after i put the hot coat on. In some areas, around the rails where my freelaps overlapped eachother there were some bubbles. I took the bubbles out with an exacto knife, so now there’s just a few dimesized/quarter sized holes in the lam, with foam exposed.

Should i fill these holes in with lam resin, or lam resin and then a hot coat?

Should i put some cloth into the holes?

the board has one layer of 4oz and one layer of 6oz on the deck of a plain white blank.

Use lam resin and cloth. Paint over the spots with a little sanding resin after it cures. Treat them like ding repairs. Mike