Sanding over logo and resin again?

General Discussion
1

Hello

I made an XPS-Epoxy Fish.

The first layer of lamination was with with pigmented epoxy resin.

After the hardening i put on my black logo.

The second layer of lamination was with clear epoxy resin.

Now the lamination is finished, the lamination isn’t smooth enough and still got some small bubbles/bumbs.

My question is. Can i sand the whole lamination again, without loosing the bright sight of my logo.

I tried it a little bit and the black logo / glass turned out white. I don’t know if the glass will turn bright again

if i’ll put on some clear resin again.

I hope someone can help, it’s my first board…

Thanks

JD

2

You should be ok

after sanding ,the next coat will clear out the dull sanded finnish

just dont sand through your logo

3

Howzit Speijk, Next time cut a piece of glass slightly bigger than your logo and lam it then hot coat. Aloha,Kokua