Good day all
I’m running Shape3D into Mach3 for my shaping machine.
When I run the machine I’m getting deceleration at the nose but at the tail it just stops dead creating shudder.
Where can I adjust this?
Cheers!
Good day all
I’m running Shape3D into Mach3 for my shaping machine.
When I run the machine I’m getting deceleration at the nose but at the tail it just stops dead creating shudder.
Where can I adjust this?
Cheers!
try nose and tail acceleration %
Update: When I adjust the acceleration and deceleration in shape3d, it works only over the ghost and stringer run. For the rest it of the board it stops dead, no deceleration.