Shaper's (layout) Square?

Does anyone know of a source for a Shaper’s Square in the US other than Foam EZ? (the Foam EZ price seems high, and their version doesn’t have the angle lines that I’ve seen on other versions). Thanks -

i’m pretty sure that the Surf Source in Jacksonville, FL sells one, although i’m not sure if it’s listed on their site or if it has the angle lines. anyhow, give it a look (http://www.surfsource.net) or give 'em a call.

Thanks for that, Soustice. I’ll give them a call.

fiberglass hawaii/santa cruz has em. i think i remember paying about $35… mine has the angle lines.

hey, just what are those angle lines anyway?

I had one but it was flimsy to me and slid around on the blank.I also wondered what the angled lines were for?Fin setup??You can make a good one with a center measure ruler and an architects triangle.Just epoxy the the triangle at the center point.The long edge of the triangle lines up on the stringer.A center ruler reads from O inches left and right.Glue thin strip of 150 grit on the back of the ruler to keep it from sliding around. RB