Shaping bay needed in or near South Orange County

General Discussion
1

Looking for a shaping bay to use. I am familiar with Foam EZ, Basham’s, Aloha Glassing and Shapers Studios. I need one that I can use without a per blank charge and where purchasing or glassing of the blank is not a requirement. I have plenty of blanks at my disposal. I have been out of the shaping room for a couple of years and just want to mow some foam to get back into my comfort zone and not worry about glassing. I have all of my own tools and always leave a clean room. My schedule is such that I can work around someone else’s. Mahalo, Alex

2

Foam ez does not require you to buy a blank nor use their tools. Just make an appointment and pay by the hour ( I think it’s like 10 bucks or something very reasonable) 

3

Thanks, I’m familiar with Foam EZ, was hoping to see if there were other options out there that I might not already know about.

Cheers

 

4

You’re in a tight spot.  Steve at Aloha used to have a spare room or two but I’m pretty sure they are being used for his own production or by others .  What you need is a shaper to share the cost of a room.  A room you could lock up and leave yor tools in.  There aren’t many of  those around.  That Industrial area behind and down the street from Foam EZ is probably your best bet.  It has been the home of  a few board building setupas over the years.  Park the SUV and prowl around on foot.  You might turn up something. Lowel

5

Thanks Lowel, good advise!