Year Built2017
ShaperCRUST
ManufacturerSOAKING UP THE UNIVERSE
Model NameNO2
LocationTELSCOMBE CLIFFS EAST SUSSEX UK
NO 2
I PURCHASED 2 BLANKS EPOXY AND ALL THE GEAR TO GO
NO2 STARTED APPREHENSIVE COS MY FIRST BOARD NO1 WENT RATHER TOO WELL BEGINNERS LUCK
I LISTENED TO TO MANY PEOPLE ON THIS ONE DO THIS DO THAT ALL GOOD FUN AND PART OF THE LEARNING PROCESS.
SO MISSION WAS STABLE SINGLE FIN WITH A RADAR SCOOP IN THE BACK TO CATCH ENERGY AND ACT AS AN FOIL, CREATING LIFT DRIVE WHEN TURNED ON RAIL, WANTED COLOUR
FAILS. LAMINATING STEPS,MMMM ALL IN ONE HIT WITH RESIN TINT NOT A GOOD IDEA SHOULD OF DONE IN SECTIONS
FAILS. BLANK HAD A LOT OF ROCKER IN IT TO MAKE IT FLAT LOST A LOT OF VOLUME
FAILS. DONT DO GREEN
FAILS. PIN STRIPING WITH EPOXY MUST USE REAL GOOD TAPE , JUST A BALLS UP
FAILS . HAD THIS COSMIC THING ON THE GO LAMINATED IN SPACE ROCKETS ECT AND IT JUST LOOKED SHIT
FAILS. MADE MY OWN TEMPLATE, NOTHING WRONG WITH THAT, THERE IS MORE TO A GOOD TEMPLATE THAN ONE WOULD THING, NX BOARD I AM USING ONE OF MY COPIED TEMPLATES IVE DRAWN ROUND A FEW OF MY MATES BOARDS THAT WORK WELL
SURFED OK THOUGH BUT NOT GOOD ENOUGH
I AM A BIT SET BACK BUT ONTO NO 3
GOOD FUN THOUGH AND A LEARNING CURVE ON TO NO 3
