So Herb, where can we get ahold of your supercharger??
So Herb, where can we get ahold of your supercharger?? …B. you can get a hold of me thru the board page. Click on one of my boards,and in the info section is a contact to …by E-mail thru Swaylocks. send me a E-mail ,and we will go from there,Herb. > Bruce Lee, said… to be like the nature of water…it seams weak(but we know it can break your board)…put it in a cup… it becomes the cup…put it in a tea pot, and boil it and the water becomes steam …then rain …to replenish…be like the nature of water. Tao of jeet kune do.
herb, i’m getting ready to shape a 6’3" semi fish out of a 6’4"R. about 20" wide, 14 3/4" tail, around 12 1/2 nose. i was going to have my glasser throw in FCS plugs for a C-5 setup, just to check it out. now however…i’m interested in adjusting exactly where he drills those plugs. i know you’ve been asked this a bunch but how close should the cannards lie to the front fins…are they centered on the front edge of front fins?..also do you group the thruster setup a little tighter like a C-5? if you’re over answering these kind of questions i understand. i haven’t actually found a thread with the specifics…anyway thanks
herb,>>> i’m getting ready to shape a 6’3" semi fish out of a 6’4"R. > about 20" wide, 14 3/4" tail, around 12 1/2 nose. i was going to > have my glasser throw in FCS plugs for a C-5 setup, just to check it out. > now however…i’m interested in adjusting exactly where he drills those > plugs. i know you’ve been asked this a bunch but how close should the > cannards lie to the front fins…are they centered on the front edge of > front fins?..also do you group the thruster setup a little tighter like a > C-5? if you’re over answering these kind of questions i understand. i > haven’t actually found a thread with the specifics…anyway thanks …No, I don’t mind at all,yes my cluster is alittle tighter and up about an inch from standard thruster settings.my superchargers are much smaller though…about 1" in base,and 1"in height.they should be about 1" away from the fin,and half its base in front of the leading edge,hope this helps,write back after you ride it on a good day, i’m always looking for input.
this is prob obvious but i assume the cannards are parallel to the front fins?
this is prob obvious but i assume the cannards are parallel to the front > fins? … not anymore,I’ve found that if you run then alittle straighter and with 1 degree or so less cant it works even better!