Hello everibody
I shaped this board. Is a 7’6" x 3" x 22"
The tail tip thIckness is half inch.
At 4" from tail its 1 1/2 inch
The midpoint of board is 3"
Should i make the board shorter and square the taill at 3" from tail or can i leave it like this?
Cheers all help is apreciated.
Leave it, glass it, ride it.
You’d be surprised how thick the rail will be after glassing. I see no problem with that rail thickness. Most new shapers make board way too thick…make sure you foil the nose and tail real good, get a proper rail outline and that board will fly. And if it sucks…sell it and make another one.
Cheers thank you very much.
Good waves
I think so also, thank you.
I hope it flys dow the line.
Thanks
Cheers and good waves
This is the best advice. Consider your board a means to an end, not the end.
Its turning out good now with the rails.
The transition looks good.
I guess it will surf.
Cheers and good waves.
