is there a way to modify the depth adjustment on the clark hitachi? so that when it is wide open the max. cut will be less than a 1/4". i read about a screw that is available for this, but am not sure. where can i get this, if it exists? that is a little too aggressive for me right now.
Teddy, LIFT THE KNOB UP UNTIL IT DOESN’T HAVE ANYMORE SLOP,NOW RAP A RUBBER BAND UNDER IT.THIS WILL SLOW THE DEPTH AJUSTMENT DOWN. Later,I can tell you how to do this on a more perm. basis using a washer or a “O” RING,but for now the rubber band should do it.Herb.
Teddy, LIFT THE KNOB UP UNTIL IT DOESN’T HAVE ANYMORE SLOP,NOW RAP A RUBBER BAND UNDER IT.THIS WILL SLOW THE DEPTH AJUSTMENT DOWN. Later,I can tell you how to do this on a more perm. basis using a washer or a “O” RING,but for now the rubber band should do it.Herb.
anyone else…any ideas…does clark sell anything?
anyone else…any ideas…does clark sell anything?