where I cut my lap the glass turned white, I know I probably waited too long to cut, but is there any trick to get rid of this? I think I heard if you rub some styrene on it that it should go away?
Yes but only for a while, it evaporates …light brushing of styrene just before hot coat can help a lot. Sytrene is a nasty chemical, be careful with it.
…monomere is kind of resin in virgin state.
Nothing work at all because you just crushed the glass so is like when you see a ding; the glass is white because was crashed.
Now the only way is to follow previous comment or take the risk and sand that ridge until the white line disappear then apply again styrene monomere
good advise…
love the avitar
Rights?
Okay thanks guys I’ll give it my best shot haha I still have to sand the lap a bit anyway I’ll see what happens. And are you talking about my avatar Mattwho?
